ECU ISO Code: 08 07 04 02 EA
2013-07-29 12:48:58
CONNECTED TO: 
Alfa Romeo GT JTS 2.0
Bosch Motronic MED7.11 EOBD Injection
--------------------------------------------------------------

Kod ISO: 08 07 04 02 EA
Numer rysunku FIAT: 55195024   
Numer sprzętu: 0261S01032 
Wersja sprzętu: 00
Numer oprogr.: 1037369653 
Wersja oprogr.: 0103
Numer homologacji:       
Data zaprogramowania: 04/06/2004

ODCZYT KODÓW BŁĘDÓW:
1: P0420 - Katalizator 1
SZCZEGÓŁY BŁĘDU:
Temperatura wody: 90,8 °C
Obroty silnika: 1840 obr/min
Obciążenie silnika: 27,00 %
Temperatura powietrza: 30,8 °C
Kąt przepustnicy: 5,88 %
Napięcie akumulatora: 13,231 V

Anomaly of the catalyzer functioning being detected in the signal emitted by the two lambda probes that are installed upstream and downstream of the catalyzer itself (with some equipments only);
check with exhaust gas analyzer and oscilloscope gases and signals of both probes before carrying out any replacements.
Powodem tego błedu jest fakt, że ECU odebrało bardzo wysoki sygnał z czujnika. Błąd obecnie jest aktywny. Podejmij stosowne działania by usunąć usterkę. Kontrolka na desce została włączona przez ten błąd. 
2: P1173 - Skład mieszanki 1 (addytywny)
SZCZEGÓŁY BŁĘDU:
Temperatura wody: 85,5 °C
Obroty silnika: 1680 obr/min
Obciążenie silnika: 21,00 %
Temperatura powietrza: 34,5 °C
Kąt przepustnicy: 4,31 %
Napięcie akumulatora: 13,231 V

The ECU has run out of range in adapting the mixture in reference to the O2 Sensor signal (multiplicative adaptation) and/or in reference to the engine running conditions (additive adaptation).
Possible causes:
- Engine Temperature sensor/circuit defective, but the signal still in realistic range.
- Fuel Pressure incorrect
- Fuel Injector(s) leaking
- Fuel Injectors clogged
- Incomplete combustion (ignition or compression problem, excess O2 in the exhaust)
- Vacuum leak (lean mixture)
- Oxygen Sensor defective or contaminated with silica (Voltage change extremely slow)
- Exhaust system leak upstream of the O2 Sensor (stray air brings extra O2 making the mixture to appear lean)
- Fuel Evaporation Control system defective
- vehicle driven out of fuel (tank empty)
Powodem tego błedu jest fakt, że ECU odebrało bardzo wysoki sygnał z czujnika. Błąd obecnie jest aktywny. Podejmij stosowne działania by usunąć usterkę. Kontrolka na desce została włączona przez ten błąd. 

KASOWANIE ZAPISANYCH KODÓW BŁĘDÓW...

ODCZYT KODÓW BŁĘDÓW:
Brak kodów błędów

